Everything you need to complete the installation of the Landing Gear Lever via Mobiflight is on this blog page.
Steps:
- Install Driver
- Install Mobiflight
- Download Mapping/Config File:
Prepar3D PMDG 737-800NGX
MSFS2020 PMDG737
X-Plane Zibo737 - Run Mobiflight
- Load the Config File into Mobiflight
- Ready to go!
If one day you need the pin map file;
1) Run Mobiflight
2) Click Mobiflight Modules
3) Select the module (Landing Gear Lever) according to the Com Port
4) Load the Module Config File into the Module
5) Restart Mobiflight
If any help is needed, feel free to contact us via Facebook, Discord or e-mail.
Best Regards,
Hello,
I am in France, and I have difficulty speaking English: sorry for the translation.
I would be interested in your landing gear 737 with annunciators, can you tell me how it connects, is a card and a script needed? I understood that it was enough to download the corresponding software, and configure it, finally is the landing gear compatible with MSFS 20 (or MSFS 24), is it delivered fully assembled and what are the delivery times.
Thank you for your information and your help.
Best regards.
Philippe
Hello Philippe,
The landing gear lever is connected via a USB.
All the annnunciators and controller are on board design.
You understand how it interface wwith your simulator correctly.
The module is fully assembled.
It’s in pre-order at the moment (07/11/2024). We can ship in 3-4 weeks.
After two months, we’ll done the mass production. Then, we’ll be able to ship in couple of days.
If you have any question, do not hesitate to contact us.
[email protected]